openocd modifications

templates/bluepill/openocd.cfg

@@ -7,6 +7,7 @@ ftdi_vid_pid 0x0403 0x6010
 # The other channel is used for UART
 # The other channel is used for UART
 ftdi_channel 1
 ftdi_channel 1
 ftdi_layout_init 0x0018 0x05fb
 ftdi_layout_init 0x0018 0x05fb
+ftdi_serial FT2XCRZ1
 
 
 # BDBUS4 is connected to JTAG TRST
 # BDBUS4 is connected to JTAG TRST
 ftdi_layout_signal nTRST -data 0x0010
 ftdi_layout_signal nTRST -data 0x0010

templates/f7/openocd.cfg

+interface ftdi
+transport select swd
+
+ftdi_device_desc "FT2232H MiniModule"
+ftdi_vid_pid 0x0403 0x6010
+ftdi_serial FT2XA9MY
+
+# The other channel is used for UART
+ftdi_channel 1
+ftdi_layout_init 0x0018 0x05fb
+
+# This is somehow necessary?
+ftdi_layout_signal SWD_EN -data 0
+
+# BDBUS4 is connected to System Reset
+ftdi_layout_signal nSRST -data 0x0010
+
+
+#set WORKAREASIZE 0x2000
+source [find target/stm32f7x.cfg]
+
+#tpiu config internal swodump.stm32f103-generic.log uart off 72000000
+
+#reset_config srst_only srst_push_pull srst_nogate connect_assert_srst
+reset_config srst_only srst_push_pull srst_nogate
+#reset_config none srst_push_pull srst_nogate
+